The handlebars and the stem determine the height and distance of the handlebars, affecting your position on the bike. Raised handlebars for an upright position in the city, straight handlebars for a sportier ride, adjustable stem to bring the handlebars closer or raise them: just a few centimetres can relieve your back and wrists.
On a classic city bike, the quill stem goes into the head tube and is adjustable in height. On newer bikes, the stem attaches to the fork steerer. An adjustable angle stem allows for fine-tuning the position, and some can be adjusted without tools.
Note the diameter of the handlebar at the centre, often 25.4 or 31.8 mm, which should match the clamp of the stem. For a quill stem, measure the diameter of the quill; for a stem on steerer, the diameter of the steerer tube. The width of the handlebar can be reduced by cutting it down, while keeping space for the levers and grips.
A higher or further back handlebar may require longer brake and gear cables. Check that they don't become taut when you turn the handlebar fully. After installation, tighten the stem and handlebar to the indicated torque, ideally with a torque wrench. An aluminium or carbon handlebar cannot withstand excessive tightening.
With a new handlebar, change your grips. The headsets and forks complete the steering system. The entire selection is in the handlebars, grips, and steering.
Ergotec offers the City EWG carrying handlebar in steel, raised handlebars, and multi-position handlebars in aluminium.
P2R provides adjustable quill stems and a fixie handlebar in aluminium.
Contec offers Sendai handlebars, the Forge High Rise stem, and the adjustable Ueda stem.
Newton has adjustable quill stems, including a model that requires no tools.
Kellys offers the Active 70 stem.
Handlebars and stems that are being phased out are gathered in the clearance spare parts, and new arrivals can be found in the new arrivals. Measure the diameter of your handlebar before ordering.
If the stem goes into the frame and is tightened by a screw on top, it's a quill stem.
No, the diameter must match. A shim only allows for the reverse, a thin handlebar in a wide stem.
Never beyond the minimum insertion mark engraved on the quill.
Yes, it provides an upright and comfortable position, which is appreciated in the city.
Check the position of the levers and the length of the cables, then ensure the brakes are functioning correctly.